![]() ![]() Thank you in advance for your insight and help. I REALLY want to use Lightburn because it is such an amazing and versatile program. ![]() I certainly would appreciate any further thoughts, advice, etc. For the Sculpfun that is normally a 20mm focus height I 3d printed a focus cylinder that is 17mm high. I will say I am a complete beginner with laser engraving and perhaps I am overlooking something minor. The first and most important thing is to drop the focus of the laser a little bit.What I try to do is set the focus point about halfway through the depth of the plywood, so for 5mm plywood I drop it about three mm. I am a bit frustrated because I have been at this for almost 2 weeks-my trial will run out soon-and I have not been able to achieve anything. I only changed one thing each time and tried for hours…nothing. I have tried the manual laser entry using GRBL and anything else listed with GRBL and systematically tried every port on the computer, every console selection, using the USB option. ![]() I know the laser works because one time it miraculously reacted to my commands to trace the perimeter of my imported piece…however I have never been able to repeat that despite not changing any of the connections, ports, etc for that one run. ![]() Well, I am sorry to report that I still am unable to connect to my Sculpfun S9 laser using my MacBook Pro running Monterey. and easy alternative to picengrave, benbox, T2laser, lightburn for who dont need more then a simple and effective tool. the hat restaurant near Amritsar Punjab coastal grandmother trademark. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |